Custom marble medallions
Send a CAD file, a hand sketch, a mood board or a photograph of an existing floor. Our design team produces a specification drawing for approval, a material study against it, and a medallion that reads as the drawing intended.
Begin a commission →
CAD, PDF, hand drawing, mood board or photograph of an existing floor
Material study returned against your drawing before cutting
Two rounds of cut-plan revision included
6–10 weeks from approved drawing
Most bespoke work starts from a client's own design — a CAD file, a hand sketch, a photograph of a floor admired elsewhere. The drawing is redrawn at full size, stones are selected against it vein by vein, and a photographic material study goes back for approval before cutting.
Because the waterjet cuts directly from the approved file, there is no interpretive drift between drawing and stone. Two rounds of cut-plan revision are included in every bespoke commission.
From your drawing to finished stone
Full-size drawing
Every pattern begins as a 1:1 cartoon on the atelier floor — proportions settled before a single slab is opened.
Stone selection
Blocks and slabs chosen against the drawing, vein by vein, photographed for your approval.
Waterjet cutting
Multi-axis waterjet direct from the approved CAD file, held to ±0.1mm across the whole figure.
Dry assembly & crating
The full composition assembled, inspected and numbered on the factory floor before export crating.
