Bathroom & spa inlay
Slip-resistant waterjet inlay engineered for bathrooms, hammams and spas — honed walking surfaces, sealed joints, and drainage falls cut into the pattern itself.
Begin a commission →Wet rooms punish every mistake. We hone walking surfaces for grip, seal every joint against standing water, and cut drainage falls into the pattern so water leaves the floor along the design's own lines.
Stones are specified for constant humidity — no iron-bearing marbles that can rust-mark, no soft limestones in the wet zone. The result is a spa floor that looks like the drawing and behaves like engineering.
Numbers that matter
Honed or leathered walking surfaces, R10 slip rating
Epoxy-sealed against standing water
Falls cut into the pattern geometry
6–10 weeks from approved drawing
Recent work in this product
Asked about bathroom & spa inlay
Dense marbles and granites without iron content. We steer you away from anything that can rust-mark or soften in humidity.
Honed and leathered finishes give an R10 rating; we can brush traffic lanes further where the spec demands.
Yes — floors, walls and vanity tops in one continuous specification, matched from the same blocks.