Bathroom & spa inlay
Slip-resistant waterjet inlay engineered for bathrooms, hammams and spas — honed walking surfaces, sealed joints, and drainage falls cut into the pattern itself.
Begin a commission →Wet rooms punish every mistake. We hone walking surfaces for grip, seal every joint against standing water, and cut drainage falls into the pattern so water leaves the floor along the design's own lines rather than fighting it.
Stones are specified for constant humidity — dense marbles and granites without iron content. We steer you away from anything that can rust-mark or soften, and match floor, wall and vanity from the same block so the room reads as one stone.
Inlay runs from floor to wall to vanity top in a single specification. A medallion can be set into the shower floor or centred in the room, and the same floral or geometric language carries across the wall panels and the bath surround.
Every piece is waterjet-cut to ±0.1mm and dry-assembled before shipping, so the wet zone — where tolerance matters most — closes tight and stays tight.
Numbers that matter
Honed or leathered walking surfaces, R10 slip rating
Epoxy-sealed against standing water
Falls cut into the pattern geometry
Floor, wall panels and vanity tops in one matched specification
6–10 weeks from approved drawing
Recent work in this product
Asked about bathroom & spa inlay
Dense marbles and granites without iron content. We steer you away from anything that can rust-mark or soften in humidity.
Honed and leathered finishes give an R10 rating; we can brush traffic lanes further where the spec demands.
Yes — floors, walls and vanity tops in one continuous specification, matched from the same blocks.
Joints in the wet zone are epoxy-sealed and the floor is cut with falls to the drain, so standing water never sits on a seam.
Photograph the room with a reference measurement and we will redraw it and match the stone and pattern.