Custom Marble Inlay in London
Bespoke marble inlay for London townhouses and estates — floors, medallions and borders drawn to your design, cut to ±0.1mm in our own factory and shipped CIF or DAP.
Get a free quote →United Kingdom
We make bespoke marble inlay for London's prime residential and hospitality projects — from Mayfair and Belgravia townhouses to country estates. The entrance hall and principal rooms are where inlay earns its place: a floor set out from the door axis, a medallion beneath the chandelier, and borders that meet the stair without a cut.
Older London buildings bring their own challenges — uneven substrates, changes of level, and existing features to respect. We plan substrate tolerance, movement joints and any underfloor heating into the cut file, and set the layout out so no field panel is cut awkwardly at the walls.
Where a floor runs through several connected rooms, we carry the border and the setting-out through the openings so the pattern reads as one continuous drawing rather than a series of separate floors. Thresholds and stair nosings are detailed in the same stone so the transitions belong.
Every piece is cut on the waterjet from the approved CAD file, dry-assembled, photographed for approval and crated with a setting plan. We ship CIF to a UK port or DAP to the address.
We work with London architects, interior designers and their contractors, issuing a cut plan and material study before cutting. If you are matching an existing floor, photograph it straight-on with a reference measurement and we will redraw the pattern.
Numbers that matter
Entrance halls, drawing rooms, stair halls, dining rooms
Calacatta, Statuario, Nero Marquina, Verde Alpi, with brass fillets
Multi-axis waterjet direct from CAD, ±0.1mm
CIF to a UK port, or DAP to the address
6–10 weeks from approved drawing, plus shipping
From drawing to crating
Full-size drawing
The pattern is drawn 1:1 on the atelier floor before any stone is cut, so proportions are settled at the scale you will walk on.
Stone selection
Blocks and slabs are chosen against the drawing, vein by vein, and photographed for your approval.
Waterjet cutting
Multi-axis waterjet cuts every piece direct from the approved CAD file, held to ±0.1mm across the whole figure.
Dry assembly & crating
The composition is assembled, inspected and numbered on the factory floor, then crated with a setting plan.
Answered for specifiers
Often, yes — photograph the floor straight-on with a reference measurement and we will reverse-engineer the pattern.
Yes — we set the design out to respect existing features and engineer for older substrates.
Panels arrive numbered with a setting plan; any competent stone installer can lay it, with remote supervision on request.
