Marble borders & accents
Marble borders frame a floor and define a room. We cut marble border designs — classic Greek key, guilloche, modern linear and bespoke — to ±0.1mm, so every marble inlay border closes with a near-invisible joint. Used as floor borders, wall accents and transitions between stones.
Begin a commission →
Greek key, guilloche, modern linear, bespoke drawn from your design
From 30mm; band, inlay and corner returns cut as one line
Multi-axis waterjet from CAD, ±0.1mm
6–10 weeks from approved drawing
A marble border is the line that frames a floor and gives a room its proportions. Run around the edge of a field, it separates the field from the walls, marks the boundary of a medallion, and absorbs the tolerances where stone meets wall or timber, so the field tiles out in whole pieces.
A border does the structural work of a floor plan. We calculate the border width from the room, then cut the band, its inlay and the corner returns as one continuous line, so the motif turns a corner without a break and never drifts. Corners are mitred and closed by hand, not butted.
Classic motifs include the Greek key, guilloche, acanthus scroll and beaded lines; modern schemes favour clean linear bands and contrasting stone fillets. Bespoke borders are drawn from your design and cut from a single waterjet file, so repeated motifs match exactly along their length.
Borders are also used vertically — as wall accents, dado lines and transitions between two marbles where a floor changes stone. Because each is cut to ±0.1mm, a border can be inlaid flush into a polished floor so the line reads as one surface rather than a raised strip.
Borders can be supplied loose for an existing floor, or cut as part of a full marble composition with the field and any medallion, so everything meets on the same joint standard. They are the least expensive way to add a bespoke, architectural line to a floor that is otherwise a simple field.
Send a plan or a length and width and we will return a border design, a cut plan and an itemised quote within three working days.
Asked about marble borders & accents
A marble border is an inlaid band that frames a floor, marks the field and absorbs the tolerances where stone meets wall or timber — in motifs such as Greek key, guilloche or clean modern lines.
Often, yes — borders can be supplied loose and cut to fit, or as part of a full composition with the field and any medallion on the same joint standard.
We calculate the width from the room so the field tiles out in whole pieces; from 30mm upward, with the band, inlay and mitred corners cut as one continuous line.
Borders, installed
